Works here (for Drive usage [not memory])...
Don't know why your text is not showing...
I added measures and meters for memory to your code (2nd circle in above image)...
thanks, i knew it was simple. however, now it says total is 16.4 gb, but i only have 6gb. i can fix this easily, but i want to know whats causing it. thanks
OH SNAP998 wrote:thanks, i knew it was simple. however, now it says total is 16.4 gb, but i only have 6gb. i can fix this easily, but i want to know whats causing it. thanks
Reading this section of the manual on memory measures should help you get what you want.
There are several types of memory and ways to read it... the one I used combines all types (Virtual Memory : RAM + RAM + Pagefile.sys).
thanks so much. I changed measure=memory > measure=physicalmemory. i knew it was a super simple solution but thanks for your help. what is the difference? i didnt really understand that page's explanation.
OH SNAP998 wrote:thanks so much. I changed measure=memory > measure=physicalmemory. i knew it was a super simple solution but thanks for your help. what is the difference? i didnt really understand that page's explanation.
Short layman's answer: Any computer operating system needs to setup several types of memory areas and reserve them for operations; swap, virtual, etc. are memory areas that are defined when the system boots, and may be from drive space, special areas of RAM, etc. together they will total more than your PHYSICALMEMORY.