Hi,
I want an Audio visualisation which is slighly curved. I gut it as I need it in Visbubble, but when I use this setup the CPU usage is 50-60% (i7).
To get the curve I need I have set the radius to 2400 and use 20 degree in total (AngleTotalDeg). I have 48 items and not anything which would explain the usage to me. When I chage the radius to "normal" the usage is down to below 10. I suggest it calculates the whole circle and need so much CPU.
Is there a better way to get the curve or another skin or a way I can drop the usage?
Thanks
It is currently April 25th, 2024, 6:15 am
Visbuble slightly curved
-
- Posts: 3
- Joined: April 16th, 2019, 11:07 am
-
- Posts: 127
- Joined: September 27th, 2017, 6:32 pm
- Location: Netherlands
Re: Visbuble slightly curved
Have you tried Yadov? I think you can achieve this effect by using the YadovCircular options in the variables file.
*shameless plug*
*shameless plug*
-
- Posts: 3
- Joined: April 16th, 2019, 11:07 am
Re: Visbuble slightly curved
Hey,
thanks a lot for this tip, I didnt know this skin had circle options as well.
Unfortunately this have the same effect, when I increase the radius of the hole.
It seems the calculation cant be done as easy as I thought.
thanks a lot for this tip, I didnt know this skin had circle options as well.
Unfortunately this have the same effect, when I increase the radius of the hole.
It seems the calculation cant be done as easy as I thought.
-
- Posts: 127
- Joined: September 27th, 2017, 6:32 pm
- Location: Netherlands
Re: Visbuble slightly curved
Rainmeter's CPU usage is only about 4% (that's normal) when I try it with those options.
-
- Rainmeter Sage
- Posts: 16168
- Joined: October 11th, 2010, 6:27 pm
- Location: Gheorgheni, Romania
Re: Visbuble slightly curved
Note that visualizer skins always tend to load more the CPU than the average skins, especially due to the reduced Update value they need to properly work. However nor they should use up to 50-60%, especially not on a modern CPU.
-
- Posts: 3
- Joined: April 16th, 2019, 11:07 am
Re: Visbuble slightly curved
Hi,JelleDekkers wrote: ↑April 25th, 2019, 9:42 am Rainmeter's CPU usage is only about 4% (that's normal) when I try it with those options.
just to be sure I need the following options to get the radius I need:
YadovCircularHoleSize=4300
YadovCircularDegreesStart=335
YadovCircularDegreesEnd=360
Your CPU is not running higher then 10%? Its fine for me until around 2500. I need a higher nubmer in Yadov as the calculation is different.
It just raises on a specific Number and grows fast after this.