The only thing I'd change in your code is that I'd rotate the meter backward (anticlockwise), probably. This is very simple, starting from your last code. There are even two different solutions:ChicknwithNoName wrote:I meant that I tried implementing balala's ActionTimer routine to your half-circle alternative, but I couldn't get the offset anchors right and so the rotation wasn't a smooth circle; it was wobbling because it was off-center.
- Replace the Rotate and IfCondition options of the [MeasureAngle] measure, as it follows:
Code: Select all
[MeasureAngle] ... Rotate=[!SetVariable Angle "(Clamp((#Angle#-10),-360,0))"]#U# IfCondition=(#Angle#<=-360)
- Leave unchanged the above options and replace the #Angle# variable in the ExtraNW, ExtraNE, ExtraSE and ExtraSW options of the [Circle] meter with -#Angle#:
Code: Select all
[Circle] ... ExtraNW=Rotate -#Angle#,50,50 | Scale #Size#,#Size#,0,0 ExtraNE=Rotate -#Angle#,0,50 | Scale #Size#,#Size#,-50,0 ExtraSE=Rotate -#Angle#,0,0 | Scale #Size#,#Size#,-50,-50 ExtraSW=Rotate -#Angle#,50,0 | Scale #Size#,#Size#,0,-50