It is currently March 29th, 2024, 7:31 am
Changing the AudioLevel Port
-
- Developer
- Posts: 22628
- Joined: April 19th, 2009, 11:02 pm
- Location: Fort Hunt, Virginia, USA
Re: Changing the AudioLevel Port
If you build one of these forks of AudioLevel, you will want to be sure to rename it, as Rainmeter will insist on using the one included with Rainmeter if there is a conflict.
-
- Rainmeter Sage
- Posts: 7029
- Joined: February 27th, 2015, 2:38 pm
- Location: Terra Yincognita
-
- Rainmeter Sage
- Posts: 16110
- Joined: October 11th, 2010, 6:27 pm
- Location: Gheorgheni, Romania
Re: Changing the AudioLevel Port
Alright, then I recommend cardencommachris to try one or more of those forks.Yincognito wrote: ↑May 22nd, 2020, 1:20 pm Just yesterday I browsed over these two forks (the 2nd one by SnGmng is supporting dynamic variables for most options (except Port and ID), as seen in the comments at the bottom of the pages):
-
- Rainmeter Sage
- Posts: 7029
- Joined: February 27th, 2015, 2:38 pm
- Location: Terra Yincognita
-
- Posts: 5
- Joined: March 3rd, 2020, 6:35 am
Re: Changing the AudioLevel Port
Balala's example with the Calc measure looked very promising. Clever, and logical. But it does not work for me (yet). Even the initial state of the Audio port being set to Output fails, on start. I'll test it a bit more.
If that fails, I'll stick a fork in it.
If that fails, I'll stick a fork in it.
Last edited by cardencommachris on May 22nd, 2020, 4:07 pm, edited 1 time in total.
-
- Posts: 5
- Joined: March 3rd, 2020, 6:35 am
Re: Changing the AudioLevel Port
There are multiple use cases for this, one being to check if your headset mic is on and working. Another is a fun concept that I don't quite want to share, yet, for fear of spoiling the joke.
-
- Posts: 5
- Joined: March 3rd, 2020, 6:35 am
Re: Changing the AudioLevel Port
Rats. unintended post. I don't see a delete option.
-
- Rainmeter Sage
- Posts: 16110
- Joined: October 11th, 2010, 6:27 pm
- Location: Gheorgheni, Romania
Re: Changing the AudioLevel Port
Post the entire code, please.cardencommachris wrote: ↑May 22nd, 2020, 4:02 pm Balala's example with the Calc measure looked very promising. Clever, and logical. But it does not work for me (yet). Even the initial state of the Audio port being set to Output fails, on start. I'll test it a bit more.
-
- Rainmeter Sage
- Posts: 16110
- Joined: October 11th, 2010, 6:27 pm
- Location: Gheorgheni, Romania
Re: Changing the AudioLevel Port
No, there is no deletion. But I can delete it for you, if you want. The above post is what you want me to delete?cardencommachris wrote: ↑May 22nd, 2020, 4:06 pm Rats. unintended post. I don't see a delete option.