Greetings Good Folks
I have an issue with my Rainmeter HWinfo addons and sensor IDs because of the headers (e.g GPUFANUSAGE). I cant seem to manage to match up the sensor ID of shared viewer to my GPUmeter.txt
I managed to get the temp right, but the rest of the figures are all over the place, -300gb +2000% fanspeed etc (as per image.jpg). The headers in the TXT file is not the same to my shared memory viewer,
if anyone could help me out, greatly appreciated. Have linked in the TXT file and a pic (look at bottom right corner)
It is currently April 19th, 2024, 2:37 am
Please help with HWinfo + GPU meter
-
- Posts: 2
- Joined: May 27th, 2018, 1:43 am
Please help with HWinfo + GPU meter
You do not have the required permissions to view the files attached to this post.
-
- Rainmeter Sage
- Posts: 5391
- Joined: April 12th, 2012, 9:40 pm
- Location: Cedar Point, Ohio, USA
Re: Please help with HWinfo + GPU meter
The HWiNFOEntryID in your code does not match the value in shared memory viewer.
0x7000000 in shared memory versus 0x8000000 in your code.
0x7000000 in shared memory versus 0x8000000 in your code.
:: My DA Gallery :: Rainmeter DA Gallery :: Rainmeter Workshops :: Rainmeter Documentation :: BBCode Guide ::
-
- Posts: 2
- Joined: May 27th, 2018, 1:43 am
Re: Please help with HWinfo + GPU meter
Hi, thats the GPU fan in the hwinfo vs the utilization rate,
pic was only to show you the headers on the shared memory isnt the same headers as the GPU ini files, so I dont know where to place the values.
pic was only to show you the headers on the shared memory isnt the same headers as the GPU ini files, so I dont know where to place the values.