I've been reading the manual looking for a way to detect pre-mixer signals, but it seems it's not possible.
Normally any LED meter's or even spectral analysers work on a signal before it gets to the master volume, so that the signal is a constant true volume of the signal being measured without interference from the master volume.
Can this be done, or is it hard wired into the plugin?
If so, could I request this to be added as an option please?
Thank you.
It is currently April 25th, 2024, 8:18 am
VU meter Pre-mixer?
-
- Posts: 1140
- Joined: February 17th, 2011, 7:45 pm
- Location: a Galaxy S7 far far away
-
- Rainmeter Sage
- Posts: 1399
- Joined: April 24th, 2021, 8:13 pm
Re: VU meter Pre-mixer?
Since you seem to have fair knowledge about sounds, take a look at this. May be helpful, may be notsl23 wrote: ↑June 19th, 2021, 12:55 pm I've been reading the manual looking for a way to detect pre-mixer signals, but it seems it's not possible.
Normally any LED meter's or even spectral analysers work on a signal before it gets to the master volume, so that the signal is a constant true volume of the signal being measured without interference from the master volume.
Can this be done, or is it hard wired into the plugin?
If so, could I request this to be added as an option please?
Thank you.
Plugin: https://github.com/d-uzlov/Rainmeter-Plugins-by-rxtd
Docs: https://li7xi.github.io/AudioAnalyzerDocs/#/home.md
Forum Post: https://forum.rainmeter.net/viewtopic.php?t=31091
from the Realm of Death
-
- Posts: 1140
- Joined: February 17th, 2011, 7:45 pm
- Location: a Galaxy S7 far far away