Yeah, to be fair, I didn't quite get what you were trying to do either, pretty much like jsmorley. Chose to guess it instead of asking, this time, hence the reply. I thought you only wanted a single Process check, since the 2nd one was blank. Anyway, it all became clearer eventually and the thing was solved, so it's all good.CodeCode wrote: ↑October 27th, 2020, 12:34 am I was sort of trying to create a method of being selective between what show and what does not - with the added ability to show both.
Jsmorley's solution provides a reasonable way for this to be carried out. As usual I was overcomplicating what already had an obvious way of being used as a solution, ergo IfCondition=
It is currently April 26th, 2024, 12:37 pm
Using Substitute To Determine if another Measure Is Showing a "1" Value
-
- Rainmeter Sage
- Posts: 7170
- Joined: February 27th, 2015, 2:38 pm
- Location: Terra Yincognita